Performance intake manifolds sorted by make - FORD

The AussieSpeed Ford six cylinder manifolds are proven performers on the drag strip and on speedway cars.

You can expect a proven 19 horsepower improvement from the old cain and current Redline manifolds, better idle and crisper throttle response.  If you don't believe me read about here on the X-Falcons forum.  Best 1/4 mile ET yet for a natuarally aspirated AussieSpeed Ford crossflow manifold of 12.989 @ 100mph and no sprayin', congratulations guys you desrve it. What an achievement for all concerned, a 0.3 second improvement over the older AussieSpeed manifold on a 13 second car with only a manifold change.

AussieSpeed Ford crossflow manifolds are proven speedway race winners, owner Adam Jorgensen of the Cortina pictured below say .." I have more torque down low and it can now pull taller gears" .... the picture says it all really.

click on photo to view larger

More success with AussieSpeed X-Flow 4 barrel manifold ~ Charles Hammond of Wangarratta in VIC replaced a tripple delorto carb set up on his AU Falcon racing track car fitted with the early crossflow engine and gained an out of the box +20hp at the rear wheels from 3800 to 6000 rpm with a 600 double pumper carb and the engine had a lot fatter and smoother torque curve than before. Total horsepower at the rear wheels is closely guarded secret but this is now a monster of an engine.

More Success with the AussieSpeed EA to AU manifold.

Rob Knox is a well known speedway racer up in Kununurra WA. Rob was running a successfully home modified standard intake manifold that accepted two throttle bodies and ran methanol through the fuel injection. After hearing about our 4 barrel manifolds for the OHC Ford 6 cylinder engine Rob gave us a call and purchased one of our AussieSpeed performance inlet manifolds. On a back to back dyno run after removing his manifold he found that the 4 barrel carb and AussieSpeed manifold running on methanol made an extra 20kW at the rear wheels and a whopping 30ftlbs more torque over his old set up. Needless to say he was wrapt and so are we.

See the 4 barrel EA to AU AussieSpeed intake manifold in action in an EB Falcon XR6 burn out car at the Murray Bridge Autofest 2010. click on the picture above to see the Video on YouTube. Stock Motor with AussieSpeed inlet manifold and a Holley 600 vac sec carb made 155 horsepower [115kW] at the rear wheels

Remember to check out our Hot Rod Cams for the Crossflow Engine click here.


     

How to Fit EA-AU AussieSpeed inlet manifold